2600 Watts SC PMA 12 VAC 3PH / 14 MAGNETS / Wind Turbine Permanent Generator

Description

If you win this auction you will get a SUPER CORE 2400 Watt
SB
(
Special Build
-
Higher voltage in wider range
)
12 Volt  AC / 3 WIRE PMA / PMG
Comes with black wires.
Works in 12 volt low wind making high amperage
and also makes over 24 volts in high winds (over 20 MPH)
Works great with our 5 blade KT blade sets.
EASY TURNING / PMA
with
super powerful 14 magnet rotor core!
This auction is for a SUPER-CORE (SC)  12VAC PMA designed
for use with our 34.64" KT propeller (blades)  and with these
blades can make up to 1645 Watts peak power in high winds (Rated as peak)
All voltage ranges (VR) are based on use for battery charging with wind power!
This PMA's is recommended for wind turbines only! Peak at about 2000 RPM.
For PMA's / PMG's  for engines / hydro use our line of #PC1212 or #QC1212 models.
SEE POWER CHART BELOW FOR ALL V.R. MODELS
These were built for an OEM customer that could not paid the bill.
These have high power coils that make more power at lower RPM's.
These feature 12 AWG wire per spec.
https://youtu.be/6lg49jmFkD8
https://youtu.be/CykfLfZ6goI
<"https://cgi5.ebay.com/slantcore_plus.jpg" target="_blank">
You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage.
Includes a real original
SUPER-CORE PMA -
The reason why they cost less
is that they are utilizing an old fashioned
The modern type PLATE AND GROOVE rotor that we have developed is the most celebrated and also the most copied type which we pioneered.  The important part is that PLATE AND GROOVE makes power at MUCH LOWER RPM's than the older and traditional Clam type rotor designs that do not provide deep magnetic saturation of the Stator coil offering 600% more power in low RPM scenarios over Clam type designs
In small wind turbines this is VERY important to make your power in the LOWER RPM ranges.
Spend a little more and get a LOT more  BANG-FOR-YOUR-BUCK!!!  Money well spent!
From the beginning GM designed the Delco to run
WET and even tested them to operate
Under Water
!
Designing an alternator that can survive at 375 degrees F. under the hood of a car operating with rain water coming through the
radiator and from water puddles is
No Easy Task!
Over 100,000,000 10/12si's were produced by Delco and after-market vendors!
Parts for this legendary 'work-horse' will be available for the next 50+ years.  World's most supported and well recognized model!
Our Magnets are on an
angle
We make our own brand new
ROTOR POLE
SHOES
AND
STATOR CORES
!!!
Our PMA's are built from the ground up using only 100% ALL new parts!
(Including the rotor pole shoes and stator coil stacks)
Our
NEW
rotor poles are balanced to within .002 grams for SMOOOOOTH rotation!
MADE IN THE USA!
Get the original
SUPER-Core PLUS+ Design.
Featuring 14 magnetic poles for achieving an amazing 35% power level increase!
Our Magnets are on an
angle
to prevent cogging!
By Hornet Power Systems
Use these powerful permanent magnet alternators (PMA's) to make cheap electricity with wind turbines
Stop wasting up to 50% of your power energizing the
coil of standard brush type alternators. Get a real PMA!